Mighty Mule 350 Manuel d'installation télécharger pdf (Page 3)

Setting FIRST arm to operate as MASTER arm:

1. The MASTER arm should be at the fully retracted position

at this time.

2. Set DIP switch #1:

OFF: pull to open

ON: push to open

3. Set DIP switch #2 and #3 (MODE 1 and MODE 2) to the desire sequence:

DIP #2 DIP #3 Dual Mode Sequence

OFF OFF Single gate mode.

ON OFF MASTER opens 1st, SLAVE opens 2 seconds later.

SLAVE closes 1st, MASTER closes 4 seconds later

OFF ON MASTER opens 1st, SLAVE opens 2 seconds later.

SLAVE closes 1st, MASTER closes 8 seconds later

ON ON MASTER and SLAVE simultaneously open and close.

4. DIP switch #4: (See main manual for additional details)

OFF: Pulse output at ‘AUX OUT’ terminal when gate is opening.

ON: Continuous output at ‘AUX OUT’ terminal when gate is moving.

Gate Operator in the

RERACTED POSITION

CONNECTING THE 45’ COMMUNICATION CABLE:

AUX

OUT

SOLAR

NEL

18VAC

RCVR

GRN

BLK

RED

EXIT

SAFETY

EDGE

CYCLE

COMMON

LINK

AUX

OUT

SOLA

NEL

18VAC

RCVR

GRN

BLK

RED

EXIT

SAFETY

EDGE

CYCLE

COMMON

LINK

45 Foot Communication

Cable run in PVC Conduit

First Gate Opener

Second Gate Opener

1. Plug the communication cable into the ‘LINK’ terminals of the opener control boards.

1 2 3 4 5 6

Commentaires sur ces manuels

Pas de commentaire

Mighty Mule 350 Manuel d'installation Page 3

Commentaires sur ces manuels

Produits connexes et manuels pour Outils de jardin Mighty Mule 350