Mighty Mule 350 Manuel d'installation télécharger pdf (Page 4)

Installing The Gate Lock

Illustration A

Lock and receiver must be level

and aligned with opener.

500

Step 1: With the gate in the closed position, determine the best location for the lock and lock receiver. The lock

and receiver must be level and aligned with the opener. Also, the lock should have a solid surface or

cross member to provide stability.

Step 2: Clamp receiver and lock together (with receiver pin hole and lock slot aligned) against the gate post,

mark their positions to drill receiver holes (see Illustration B and C, page 3). The receiver must be

mounted with carriage bolts, not U-bolts, to allow lock to seat properly. Fasten the receiver to the gate

post.

Step 3: Hold latch open with key to operate gate and check closed limit and lock alignment. Drop pin in receiv-

er but don't put the cap on. Recheck the lock's position and alignment, then mark its position for drilling

holes.

Step 4: Drill the holes on gate supports through the slots in the lock bracket. U-bolts and saddles can be used

to mount the lock on chain link gate supports. Secure the lock to the gate. Install clevis pin and locking

cap by placing clevis pin through slots in lock receiver and hammering the clevis pin into the locking

cap (see Illustration D), secure the lock bracket and check the alignment again.

NOTE: The Automatic Gate Lock can be installed on single and dual gate systems. Use the appropiate

instructions for the system you have - SINGLE GATE (below) or DUAL GATES (page 4).

Turn power switch OFF on the bottom of the control box. Disconnect gate opener by removing hairpin

clip and clevis pin from the gate bracket end of the opener. Disconnecting the opener will allow the gate

to swing freely during installation of the gate lock.

Single Gate Installation

1 2 3 4 5 6 7 8 9 ... 13 14

Pas de commentaire

Mighty Mule 350 Manuel d'installation Page 4